Refurbished Hunter Ceiling Fans With Light and Remote

Disconnecting the wires to a ceiling fan light switch.

If your paddle ceiling fan's lights no more work, the culprit is commonly the pull-chain light exchange decorated on the bottom of the lover.

Here's how to test and replace the switch.

To determine if the pull chain switch is abnormal:

1. • Turn off the power to the fan at the breaker.

• • Remove the compensate plate on the bottom of the fan.

• • Disconnect the wires coming from the switch to the lights.

• • Have sure the wires are not touching anything, then turn of events the top executive back on at the breaker.

• • Check the trade wires with a potential examiner to find if power is coming from the flip-flop to the lights.

• • If electricity is present below the switch, the problem is either in the wires going to the light, the bulb sockets, or the light bulbs.

• • If electricity is not present below the trade, turn the world power to the fan pull out.

• • Disconnection the wires coming into the switch from the fan.

• • Make sure the wires are not poignant anything, so crook the power back on at the breaker.

• • Check the wires coming into the switch from the fan with a voltage quizzer to witness if power is coming from the sports fan to the switch.

• • If electricity is non coming from the fan to the electric switch, the trouble is with the fan wiring rather than the switch.

• • If electrical energy is coming from the fan to the flip, the job is with the take out chain switch.

• If the switch is the trouble, remove the switch, supervene upon it with a new switch, reattach the wires, turn the baron back on, and side the string on the switch to see if the lights work.

Lookout man this video to find outgoing more.

Further Data

• How to Replace a Dodder Ceiling Fan Pulling Chain Switch (article)
• How to Catch Tilt and Quiver in a Paddle Ceiling Lover (article)
• How to Fix an Out of Balance Cap Fan (video)
• How to Control a Cap Fan Without a Wall Switch (article)
• How to Set up a Paddle Ceiling Fan (video recording)

VIDEO TRANSCRIPT
Danny Lipford: Recently a homeowner asked ME if their ceiling fan light kit could be repaired without replacing the whole thing. If the buff still works well, information technology's meriting looking into the light kit.

If there are no loose wires visible, the perpetrator is likely a faulty pull along chain switch. To check, put off the power at the breaker box, and disconnect the wires coming from the switch to the lights. Be sure that the wires are not affecting anything before you turn the power back on, and test the wires with a voltmeter.

If No voltage is give, become the power back off, and unplug the wires upcoming into the switch from the buff. Over again, be sure no wires are touching anything ahead turning happening the power to test them with the meter.

If voltage is on hand above the switch, but not on a lower floor IT, then the switch is mediocre. A permutation pull chain tack is only a couple of dollars and should screw into on the nose the Lapplander emplacemen as the old one.

With the power off, connect one side of the switch to the wires future day in from the fan, and the other side to the wires feeding the lights.

Refurbished Hunter Ceiling Fans With Light and Remote

Source: https://todayshomeowner.com/video/how-to-fix-a-paddle-ceiling-fan-light-switch/